電力中央研究所

報告書「電力中央研究所報告」は当研究所の研究成果を取りまとめた刊行物として、昭和28年より発行されております。 一部の報告書はPDF形式で全文をダウンロードすることができます。

※ PDFのファイルサイズが大きい場合には、ダウンロードに時間がかかる場合がございます。 ダウンロードは1回のクリックで開始しますので、ダウンロードが完了するまで、複数回のクリックはなさらないようご注意願います。

電力中央研究所 報告書(電力中央研究所報告)

報告書データベース 詳細情報


報告書番号

H07016

タイトル(和文)

浅層埋設トラフ内に設置されるケーブル許容電流の検討

タイトル(英文)

Permissbile Ampacity estimation of Power Cables Installed Shallow Underground

概要 (図表や脚注は「報告書全文」に掲載しております)

浅層埋設トラフ方式で設置されるケーブルの温度上昇を実験的に把握し、当該方式におけるケーブル許容電流算出手法を提案した。ケーブル許容電流算出手法については、実測値と計算値は比較的よく一致し、浅層埋設トラフ内布設ケーブルにも土壌を介しての放熱を考慮した土壌熱抵抗計算手法が適用可能であることがわかった。また、浅層埋設トラフ内に設置されるケーブルの許容電流算定時の基底温度として、地中送電線の暗渠について設定されている40℃を用いると、ケーブル導体温度の許容値を超える可能性が多分にあるので、数℃程度高めに設定することを推奨した。さらに、地中送配電線等のケーブル許容電流検討に用いられている日変動負荷を等価な平均定常負荷に換算する損失率は適用できないことがわかった。

概要 (英文)

The heat radiation characteristic of the cable set up in the shallow underground was experimentally estimated, and calculation method for the permissible ampacity of such cables were proposed. In the temperature rise tests, the measurement values and the calculation results are corresponding comparatively well, and it has been clarified that the conventional calculation method of the cable permissible ampacity by considering heat radiation through the soil is applicable to the cable set up in the shallow underground. The base temperature in the underground channel for the power cable is usually regarded as 40C,but there is a possibility that the temperature of the conductor exceed its allowable range in the case of the cable set up in the shallow underground, therefore the base temperature should be several degrees higher.
In addition, the loss factor, which is introduced in order to regard a cyclic load as an equivalent average constant load could not be applied attentively in the shallow underground.

報告書年度

2007

発行年月

2008/06

報告者

担当氏名所属

堀 康彦

電力技術研究所 機器絶縁領域

伊藤 哲夫

電力技術研究所 機器絶縁領域

鈴木 寛

電力技術研究所

キーワード

和文英文
配電地中化 underground distribution system
浅層埋設 shallow installation
許容電流 permissbile ampacity
ケーブル cable
トラフ trough
Copyright (C) Central Research Institute of Electric Power Industry