電力中央研究所

報告書「電力中央研究所報告」は当研究所の研究成果を取りまとめた刊行物として、昭和28年より発行されております。 一部の報告書はPDF形式で全文をダウンロードすることができます。

※ PDFのファイルサイズが大きい場合には、ダウンロードに時間がかかる場合がございます。 ダウンロードは1回のクリックで開始しますので、ダウンロードが完了するまで、複数回のクリックはなさらないようご注意願います。

電力中央研究所 報告書(電力中央研究所報告)

報告書データベース 詳細情報


報告書番号

W98018

タイトル(和文)

石炭ガス用高性能乾式脱硫剤の開発 -亜鉛フェライト脱硫剤の最適再生条件の検討-

タイトル(英文)

Development of Advanced Desulfurization Sorbent for Hot Coal Gas Clean-up - Study on Optimum condition for Regeneration of Zinc Ferrite Sorbent-

概要 (図表や脚注は「報告書全文」に掲載しております)

当所は、既に1ppm以下まで除去できる亜鉛フェライト脱硫剤の試作に成功した。この脱硫剤では、脱硫時に吸収した硫黄分を酸素(O2濃度:1.5%程度)と反応させ、二酸化硫黄(SO2)として放出させて、再生利用する。このときの再生条件について検討し、以下の結果を得た。①反応器入口再生ガス中にSO2を含むとSO2を含まない場合より、再生後の1ppm以下を維持する時間(1ppm破過時間)が短くなった。また、再生ガス温度600℃で再生した場合、450℃で再生した場合より1ppm破過時間は短くなった。このことから、SO2を含まない再生ガスを用い、450℃のガス温度で脱硫剤を再生することが最適であると判明した。②SO2を含むガス用いた再生での脱硫性能の低下は硫黄分吸収容量の減少が原因であり、600℃再生では脱硫剤の比表面積の低下が原因であることが判明した

概要 (英文)

we have been developing an advanced desulfurization sorbent which remove sulfur compounds(H2S,COS) below 1ppm for Hot coal gas clean-up to put an integrated coal gasification molten carbonate fuel cells power generation system (IG-MCFC) into practice and reduce SO2 emmission from an integrated coal gasification combined cycle power generation system (IGCC). We already prepared Zinc Ferrite sorbent.After desulfurization, sulfided sorbent is regenerated with O2 containing gas. Abosorbed sulfur is released as SO2. SO2 is recovered as sulfur or gypsum. SO2 recovered gas is recycled. Characteristics of regeneraion of sorbent is influenced by unrecovered SO2 and gas temperature. We studied on the influence of SO2 and gas temperature and obtained following results. (1) 1ppm breakthrough time at desulfurization after regenaratin with 0.2%SO2-1.6%O2-N2 gas was shorter than that after regenaration with SO2 free gas (1.6%O2-N2) in a fixed bed reactor. (2) 1ppm breakthrough after regeneration in inlet gas temperature of 600゚C was shorter than that at 450゚C. (3) The drop of sorbent performance after regeneration with SO2 containing gas was cause by the decrease of sulfur abosorbing capacity and The drop of performance after regeneration at 600゚C was cause by sintering of sorbent. From these results, we shoud select hight efficient sulfur recovery method and reduced SO2 concentration of regeneration gas.

報告書年度

1998

発行年月

1999/04

報告者

担当氏名所属

白井 裕三

横須賀研究所エネルギー化学部

小林 誠

横須賀研究所エネルギー化学部

布川 信

横須賀研究所エネルギー化学部

キーワード

和文英文
乾式吸硫剤 High-Temperature Desulfurization Sorbent
石炭ガス Coal-Derived Gas
脱硫サイクル Desulfurization Cycle
劣化特性 Deterioration Characteristic
微量不純物 Trace Contaminant
Copyright (C) Central Research Institute of Electric Power Industry